『必要?不必要?スーパーツィーター vol.14』の続きです。
実験では下図のような接続をしました。
bba30と試作機No.1は内部にそれぞれ緩衝増幅器があります。
緩衝増幅器を1つにする方法はないのでしょうか?
今回は低域フィルターと高域フィルターという周波数の離れたフィルターなので
1つにできると思われます。
次のようなブロック図になります。
この場合、高域フィルター部に対する緩衝増幅器はありませんので
この高域フィルターに汎用性はありません。
つまり、bba30に接続するためのみに使用できる高域フィルターになります。
他の機器に接続しても高域フィルターとして正常に動作しません。
bba30専用です。
回路図は以下のようになります。
次回に続きます。
あと3日となりましたが、11月30日まで秋の新製品発売キャンペーンを行っています。
Necessity? Unnecessary ? super tweeter vol.15
It is a continuation of "Necessity? Unnecessary ? super tweeter vol.14"
In the experiment, connection as shown in the following figure was made.
bba30 and experimental model No.1 have a buffer amplifier
in an inside, respectively.
Can a buffer amplifier be set to one?
It is separated from the bass filter and the treble filter of frequency.
Therefore, it is compoundable.
Block diagram:
In this case, there is no buffer amplifier to a high-pass-filter part.
Therefore, flexibility is not in this high-pass filter.
It is a filter only for connecting with bba30.
When it connects with other apparatus, it does not operate normally as a filter.
It is bba30 exclusive use.
Circuit diagram:
To be continued.