ムジカ公式ブログ MUSICA Official weblog

オーディオと音楽とすこしマニアック。 MUSICA are a new Hi-Fi brand from Japan.

一万円の抵抗はどのくらい高音質なのか? vol.10

2015-02-10 | 30シリーズ 30series

一万円の抵抗はどのくらい高音質なのか? vol.9』の続きです。

カソード・フォロアーの負荷抵抗を1ヶ所だけ変えてテストします。

カソード・フォロアー回路を搭載しているUSB-DAC usb30で実験してみます。



usb30には3極管のサブミニチュア管が使われています。



音質ですが・・・

Taylor Swift 1989では



音の芯がしっかりと再生されます!

Jazzやロックのパンチの効いた曲では良い感じです。

変化の度合いは僅かですが

サンプリングが96KHzと192KHzのDACの差よりははるかに大きいと感じます。

次回に続きます。


お問い合わせの多いアウトレットモールはこちらです

アウトレットモールでは30シリーズの特集をしています。


Is the resistor at 100 dollars high quality sound? vol.10

It is a continuation of "Is the resistor at 100 dollars high quality sound? vol.9"



A sub-miniature tube of a triode is used for usb30.



It's the sound quality....



A core of sound is recycled correctly in Taylor Swift 1989!

I'd like Jazz and a lock.

The degree of the change is little.

But,I find sampling to be quite bigger than the difference in DAC of 96KHz and 192KHz.

To be continued.

An overseas dealer and mail-order sites for the users opened.

It's cipango.

Raicho is being sold.

Other models would be sold by your request.
コメント
  • X
  • Facebookでシェアする
  • はてなブックマークに追加する
  • LINEでシェアする

超高域再生でレコード再生が変わる?!vol.1

2015-01-14 | 30シリーズ 30series

レコードを再生する場合、

RIAAカーブという再生カーブによって

20KHzは1KHzに対して約1/10になるように設定されています。

20年程前、当時とても有名だったメーカーの設計者の方と

お話をしたとき、

あるメーカーでは20KHz以上の超高域を上昇させているとのこと。

その方が言われるには

『RIAAカーブは20KHzまでしか規定がなく

超高域(例えば30KHz)は自由に設定しても問題がない。

その帯域を変化させることで

フォノアンプの音質が大きく変わる。』とのことでした。

そこでそのメーカーでは・・・

次回に続きます。


お問い合わせの多いアウトレットモールはこちらです


Ibukiのモニター使用テスト第2弾

Ibuki-phonoのモニター使用テスト募集中です!



Super-treble and analogdisk vol.1

When analog disk is played, RIAA turn are used.

20KHz is established as it'll be about 1/10 to 1KHz.

Before about 20 years, it was discussed with a very famous engineer then.

They seem to be making one beyond 20KHz rise by the manufacturer which has that.

There is a regulation only to 20KHz for a RIAA turn.

30KHz may be established freely.

When changing the band, the sound quality of FONOANPU turns big.

He said so.

So by the manufacturer...

To be continued
コメント
  • X
  • Facebookでシェアする
  • はてなブックマークに追加する
  • LINEでシェアする

モノラルアンプは音が良い?? vol.8

2014-10-01 | 30シリーズ 30series

モノラルアンプは音が良い?? vol.7』の続きです。

これまでモノラルパワーアンプについて述べてきましたが、

モノラルプリアンプというのはあまり聞きません。

効果はパワーアンプ同様大きいはずです。

しかし、ボリュームコントロールが左右別々というのは・・・

なんとも使いにくそうです・・・

実際のところはどうなのでしょう?

パッシブアッテネーターatt60/taをモノラル化の改造をして



実験してみましょう。

次回に続きます。



Mono-amp is good?? vol.8

It is a continuation of "Mono-amp is good?? vol.7"

Monophonic power amplifier has so far been described.

However, there is almost no monophonic preamplifier.

It will be effective like power amplifier.

However, I think that it is hard to use

when volume control has been independent by Rch/Lch.

In practice, it will be how?

The passive attenuators att60/ta are monophonic-recording-ized,



and it experiments in them.

To be continued.
コメント
  • X
  • Facebookでシェアする
  • はてなブックマークに追加する
  • LINEでシェアする

モノラルアンプは音が良い?? vol.7

2014-09-30 | 30シリーズ 30series

モノラルアンプは音が良い?? vol.6』の続きです。

これまでモノラルアンプの優位性を述べてきましたが、

モノラルアンプにも欠点はあります。

機種選択の余地が少ないという点です。

ステレオアンプに比べて圧倒的に種類の少ないモノラルアンプに

自分好みの音色を見つけ出すのは困難です。

対応策として、

ステレオアンプの片チャンネルだけを使用する方法があります。

コストは2倍かかりますが・・・

ステレオアンプの片チャンネルだけを使用する場合、

いくつかの注意が必要です。

1、入力をショートする。

必ずショートピンを使用してください。



ショートピンを使用しない場合、ノイズが混入し、

使用しているチャンネルにも悪影響を与えます。

2、出力に負荷抵抗を使用する。

出力(スピーカー端子)が開放の場合、

アンプが発振する可能性があります。

発振防止には4~40オームで5~10ワットの抵抗が適しています。



この2点は必ず使用してください。

次回に続きます。

Mono-amp is good?? vol.7

It is a continuation of "Mono-amp is good?? vol.6"

The predominancy of mono-amplifier has been described.

However, mono-amplifier also has a fault.

There is little room of model selection.

Monophonic amplifier has few kinds compared with stereo amplifier.

It is difficult to find out a favorite tone.

As measures, there is the method of using the one channel of stereo amplifier.

Cost is twice...

Some cautions are required

when using only one channel of stereo amplifier.

(1) Input are short-circuited.

Please be sure to use a short pin.



When not using a short pin,

a noise mixes and the channel currently used has a bad influence.

(2) Load resistance is used for an output.

When an output (speaker terminal) is opening,

amplifier may be in an oscillation state.

The resistor (4-40 ohms / 5-10 W) fits prevention from an oscillation.



Please be sure to use these two points.

To be continued.
コメント
  • X
  • Facebookでシェアする
  • はてなブックマークに追加する
  • LINEでシェアする

モノラルアンプは音が良い?? vol.6

2014-09-29 | 30シリーズ 30series

モノラルアンプは音が良い?? vol.5』の続きです。

ステレオアンプの中には、

スイッチを切り換えるとモノラルアンプとして動作するものがあります。

これならば、現在使用しているアンプを

もう1台買い足してモノラルアンプとして使用することができます・・・が、

あまりお勧めしません・・・

オーディオアンプは数百~数千点のパーツで作られています。

これらのパーツの一部がロットによって異なるということはよくあることです。

また、作り手が変わってくれば音質も異なります。

生産時期の異なるアンプは別物と考えるべきです。

次回に続きます。

アウトレットでは9月末の決算に向けてセールを行っています。



Mono-amp is good?? vol.6

It is a continuation of "Mono-amp is good?? vol.5"

Stereo amplifier has some which operate as mono-amplifier,

if a switch is switched.

One more set of amplifier can be purchased

and it can be used as monophonic amplifier.

I do not recommend it to you.

Audio amplifier is made from several 100 and thousands of parts.

Some parts may change with lots.

Moreover, when a producer changes, sound qualities differ.

You should consider "the amplifier with which production time differs"

to be a different thing.

To be continued.
コメント
  • X
  • Facebookでシェアする
  • はてなブックマークに追加する
  • LINEでシェアする