OBD-II code reader to diagnose the problem, your Auto Tools. Production since 1996, all vehicles are equipped with onboard diagnostic II computer. The computer detected the error code and warning and service lights on the dashboard to remind you that your vehicle inspection and repair machinery. These codes can be read by the code reader of the OBD-II, and later erased, thereby resetting the computer on and off the warning and services over the lamp. These code reader is also referred to as the scanner can be purchased from the local auto parts retailer.
1
Look for the diagnostic link under the driver's Auto code reader. This is usually found in the steering column to the left or right. OBD II scanner is connected to the port.
2
Insert the key into the ignition switch, and put it in the "on" position, but do not start the car. This is the power of the scanner. Select the command "View Code" or a similar command.
3
Write down a numeric code, and look forward to their scanner operations manual.
4Unplug the scanner and vehicle maintenance or repair.
5
Repeat step 1. In order to insert the key into the ignition switch and open its "open" position. Select "delete code" option, and then wait for the scanner to complete the task. Unplug the scanner.
6
Start the engine and verify that all services and OBDII Breakout Box are turned off.
Tip:
You can borrow a scanner is usually free of charge from your local auto parts store.
1
Look for the diagnostic link under the driver's Auto code reader. This is usually found in the steering column to the left or right. OBD II scanner is connected to the port.
2
Insert the key into the ignition switch, and put it in the "on" position, but do not start the car. This is the power of the scanner. Select the command "View Code" or a similar command.
3
Write down a numeric code, and look forward to their scanner operations manual.
4Unplug the scanner and vehicle maintenance or repair.
5
Repeat step 1. In order to insert the key into the ignition switch and open its "open" position. Select "delete code" option, and then wait for the scanner to complete the task. Unplug the scanner.
6
Start the engine and verify that all services and OBDII Breakout Box are turned off.
Tip:
You can borrow a scanner is usually free of charge from your local auto parts store.