How to read & decode BMW CAS4 5M48H with XPROG-M Programmer?

This article shows the procedures on reading & decoding BMW CAS4 5M48H with XPROG-M Programmer.

 

Procedures:

Remove BMW CAS4 module and get 5M48H controller from PCB

Then weld it on the XPROG-M adpater

Run XPROG software,and click [Device] button

Select [Immobilizers]–>[CAS4 1N35H 5M48H…1030 v1]–>[1N35H_5M48H_D-FLASH_v1]

Now click [Read] button

The XPROG-M programmer indicate light will flash

Progress…

It will show you with the information as below

After then you can get the D-Flash data,save it on you laptop