OBDSTAR X300 DP Plus program mileage on Benz W169

Today Leo showed us how to use obdstar X300 DP Plus to program mileage on Benz A169, please note, what he used is a testing kit, in the real test, you need only use the OBDII cable to connect the machine and the OBD port of the Benz instead of dismantle the dashboard.

Connection.

Tap “Cluster calibration”.

Tap “Benz”.

Initial communication failed, please confirm that the diagnostic line is connected normally.

Communicating successfully.

Enter A series -> W169

Switch ignition on.

Reading mileage.

Current mileage 8015KM.

Please input the mileage of the adjustment.

The dashboard will automatically turn off and on, means the machine is communicating with it.

OBDSTAR X300 DP Plus Do GM Opel Bosch BCM Clone

This article show a guide on how to use OBDSTAR X300 DP Plus to clone GM Opel Bosch BCM.You can copy the original ECU data,and then
write the data into another same ECU hardware via X300 DP Plus,so that
it can achieve the same function as the original ECU.Let’s jump right
in!

Procedure:

Select “ECU Clone”==>GM

GM V30.01,and tap “OK”

Select “Auto” and tap “OK”

It prompt with the information “This function is available by
connecting the server,please ensure the Internet connection is normal”

Tap “OK” to continue

Select “Read EEPROM”,and click “OK”

Enter a filename to save

File saved success

Select “Read FLASH”

Enter a filename to save

Click “Write EEPROM”

Select the data file you saved before

Logging system…

Restoring EEPROM…

Successful data recovery

Select “Write FLASH”

There are certain risks in operating this function.Does it continue?

Remember:During operation,make sure that the vehicle is fully powered and do not disconnect the device.Tap “OK” to continue

Select the FLASH file you saved before,then tap “OK” to continue

Logging system…

Restoring FLASH…

Successful data recovery

Done!