『アッテネーターの音。プリの音。vol.14』の続きです。
パッシブアッテネーターに対するパワーアンプの影響を低く抑えるために、
パッシブアッテネーターのボリュームの位置を
20%以下や80%以上で使用すればよいことが分かりました。
パッシブアッテネーターはプリアンプと違ってゲインがありませんので
普通に使用しても70%位になると思います。
また、ゲインの可変ができるパワーアンプでしたら
適正音量のときに80%位の位置になるように
設定するとよいと思います。
『プリアンプだとボリュームの位置が9~11時だったが、
パッシブアッテネーターでは2~4時になった。』という
お問い合わせをいただくことがありますが
パッシブアッテネーターを使用する上では、むしろ好都合なのです。
次回に続きます。
8月24日まで、
ムジカWEB SHOP及び、ムジカ アウトレットショップ限定の
夏休みプレゼントキャンペーンを行っています。
Attenuator's sound. Pri-amp's sound. vol.15
It is a continuation of "Attenuator's sound. Pri-amp's sound. vol.14"
In order to suppress low the influence of power amplifier on a passive attenuator,
It turned out that the position of volume may be used at 20% or less and 80% or more.
Since a passive attenuator does not have a gain unlike a preamplifier,
It will become about 70%, even if it uses it ordinarily.
Power amplifier of a variable profit,
It is good to set to 80% of position at the time of proper volume.
"when it was a preamplifier, the position of volume was 30%,
but in the passive attenuator, it became 70-80%. "
There is such a report.
It is convenient when using a passive attenuator.
To be continued.