CCNP ROUTE 300-101 exam questions

Do you want to pass the Cisco 300-101 exam better and faster? Then please select the CertTree. It can help you achieve your dreams. CertTree is a website that provide accurate CCNP ROUTE 300-101 exam questions for people who want to participate in the IT certification. CertTree can help a lot of IT professionals to enhance their career blueprint. Our strength will make you incredible. You can try a part of the questions and answers about Cisco 300-101 exam to test our reliability.

300-101 test is a very valuable and important exam of Cisco Certification. 300-101 exam is a very authentic and very much valuable exam for the IT professionals. 300-101 exam is an ideal exam for those IT professionals who want to improve their skills, talent and knowledge about the information technology. CCNP ROUTE 300-101 exam questions from CertTree will certainly assist you in gaining the knowledge and experience needed to study for your 300-101 exam. CCNP ROUTE 300-101 exam questions are very advanced and always updated with the changing 300-101 Exam Objectives to equip you with all the necessary concepts and ideas to succeed in both the 300-101 Exam and Practical Life.
Share some CCNP 300-101 exam questions and answers below.
On which two types of interface is Frame Relay switching supported? (Choose two.)
A. serial interfaces
B. Ethernet interfaces
C. fiber interfaces
D. ISDN interfaces
E. auxiliary interfaces
Answer: A,D

Which statement is true?
A. RADIUS uses TCP, and TACACS+ uses UDP.
B. RADIUS encrypts the entire body of the packet.
C. TACACS+ encrypts only the password portion of a packet.
D. TACACS+ separates authentication and authorization.
Answer: D

In IPv6, SLAAC provides the ability to address a host based on a network prefix that is advertised from a local network router. How is the prefix advertised?
A. routing table
B. router advertisements
C. routing protocol
D. routing type
Answer: B

Which two routing protocols are supported by Easy Virtual Network? (Choose two.)
A. RIPv2
B. OSPFv2
C. BGP
D. EIGRP
E. IS-IS
Answer: B,D

A network engineer is considering enabling load balancing with EIGRP. Which consideration should be analyzed?
A. EIGRP allows a maximum of four paths across for load balancing traffic.
B. By default, EIGRP uses a default variance of 2 for load balancing.
C. EIGRP unequal path load balancing can result in routing loops.
D. By default, EIGRP performs equal cost load balancing at least across four equal cost paths.
Answer: D

An engineer is configuring a GRE tunnel interface in the default mode. The engineer has assigned an IPv4 address on the tunnel and sourced the tunnel from an Ethernet interface. Which option also is required on the tunnel interface before it is operational?
A. tunnel destination address
B. keepalives
C. IPv6 address
D. tunnel protection
Answer: A


Our PDF of 300-101 exam is designed to ensure everything which you need to pass your exam successfully. At CertTree, we have a completely customer oriented policy. We invite the rich experience and expert knowledge of professionals from the IT certification industry to guarantee the PDF details precisely and logically. Our customers' time is a precious concern for us. This requires us to provide you the products that can be utilized most efficiently.

300-115 CCNP SWITCH exam dumps

CertTree 300-115 CCNP SWITCH exam dumps provide you with an opportunity to test your knowledge and skills in a simulated, certification-testing environment.Various websites offering such information have information in various formats you can easily download the format that is suitable for you it can be in Cisco 300-115 pdf or in html.


CertTree 300-115 CCNP SWITCH exam dumps are developed in such a way in which all the candidates can prepare exam anywhere, anytime. Printable PDF helps candidates to have the hardcopy with them and study anytime, anywhere. Installable application helps them in practicing the questions while they are in office or at home. Online Tool helps everyone who just have an internet connection with him/her on any device and he/she can study. By providing all these products; CertTree wants you to pass and become 300-115 certified.
Share some CCNP 300-115 exam questions and answers below.
Interface FastEthernet0/1 is configured as a trunk interface that allows all VLANs. This command is configured globally: monitor session 2 filter vlan 1 - 8, 39, 52
What is the result of the implemented command?
A. All VLAN traffic is sent to the SPAN destination interface.
B. Traffic from VLAN 4 is not sent to the SPAN destination interface.
C. Filtering a trunked SPAN port effectively disables SPAN operations for all VLANs.
D. The trunk's native VLAN must be changed to something other than VLAN 1.
E. Traffic from VLANs 1 to 8, 39, and 52 is replicated to the SPAN destination port.
Answer: E


A network engineer must set the load balance method on an existing port channel.
Which action must be done to apply a new load balancing method?
A. Configure the new load balancing method using port-channel load-balance.
B. Adjust the switch SDM back to "default".
C. Ensure that IP CEF is enabled globally to support all load balancing methods.
D. Upgrade the PFC to support the latest load balancing methods.
Answer: A


Which statement about Cisco devices learning about each other through Cisco Discovery Protocol is true?
A. Each device sends periodic advertisements to multicast address 01:00:0C:CC:CC:CC.
B. Each device broadcasts periodic advertisements to all of its neighbors.
C. Each device sends periodic advertisements to a central device that builds the network topology.
D. Each device sends periodic advertisements to all IP addresses in its ARP table.
Answer: A


A manager tells the network engineer to permit only certain VLANs across a specific trunk interface.
Which option can be configured to accomplish this?
A. allowed VLAN list
B. VTP pruning
C. VACL
D. L2P tunneling
Answer: A


After UDLD is implemented, a Network Administrator noticed that one port stops receiving UDLD packets. This port continues to reestablish until after eight failed retries. The port then transitions into the errdisable state.
Which option describes what causes the port to go into the errdisable state?
A. Normal UDLD operations that prevent traffic loops.
B. UDLD port is configured in aggressive mode.
C. UDLD is enabled globally.
D. UDLD timers are inconsistent.
Answer: B


While working in the core network building, a technician accidently bumps the fiber connection between two core switches and damages one of the pairs of fiber. As designed, the link was placed into a non-forwarding state due to a fault with UDLD. After the damaged cable was replaced, the link did not recover.
What solution allows the network switch to automatically recover from such an issue?
A. macros
B. errdisable autorecovery
C. IP Event Dampening
D. command aliases
E. Bidirectional Forwarding Detection
Answer: B


When a Layer 2 EtherChannel is configured, which statement about placement of the IP address is true?
A: The IP address is placed on the highest numbered member port.
B: The IP address is placed on the port-channel logical interface.
C: The IP address is placed on the lowest numbered member port.
D: The IP address is assigned via DHCP only.
Answer: B

A network engineer has just deployed a non-Cisco device in the network and wants to get information about it from a connected device. Cisco Discovery Protocol is not supported, so the open standard protocol must be configured.
Which protocol does the network engineer configure on both devices to accomplish this?
A. IRDP
B. LLDP
C. NDP
D. LLTD
Answer: B


Which statement about the use of SDM templates in a Cisco switch is true?
A. SDM templates are used to configure system resources in the switch to optimize support for specific features, depending on how the switch is used in the network.
B. SDM templates are used to create Layer 3 interfaces (switch virtual interfaces) to permit hosts in one VLAN to communicate with hosts in another VLAN.
C. SDM templates are used to configure ACLs that protect networks and specific hosts from unnecessary or unwanted traffic.
D. SDM templates are used to configure a set of ACLs that allows the users to manage the flow of traffic handled by the route processor.
E. SDM templates are configured by accessing the switch using the web interface.
Answer: A


While doing network discovery using Cisco Discovery Protocol, it is found that rapid error tracking is not currently enabled.
Which option must be enabled to allow for enhanced reporting mechanisms using Cisco Discovery Protocol?
A. Cisco Discovery Protocol version 2
B. Cisco IOS Embedded Event Manager
C. logging buffered
D. Cisco Discovery Protocol source interface
E. Cisco Discovery Protocol logging options
Answer: A


A new network that consists of several switches has been connected together via trunking interfaces. If all switches currently have the default VTP domain name "null", which statement describes what happens when a domain name is configured on one of the switches?
A. The switch with the non-default domain name restores back to "null" upon reboot.
B. Switches with higher revision numbers does not accept the new domain name.
C. VTP summary advertisements are sent out of all ports with the new domain name.
D. All other switches with the default domain name become VTP clients.
Answer: C


An engineer is configuring an EtherChannel between two switches using LACP. If the EtherChannel mode on switch 1 is configured to active, which two modes on switch 2?establish an operational EtherChannel? (Choose two.)
A: active
B: auto
C: desirable
D: on
E: passive
Answer: A, E

Which statement about LLDP-MED is true?
A. LLDP-MED is an extension to LLDP that operates between endpoint devices and network devices.
B. LLDP-MED is an extension to LLDP that operates only between network devices.
C. LLDP-MED is an extension to LLDP that operates only between endpoint devices.
D. LLDP-MED is an extension to LLDP that operates between routers that run BGP.
Answer: A


In which portion of the frame is the 802.1q header found?
A. within the Ethernet header
B. within the Ethernet payload
C. within the Ethernet FCS
D. within the Ethernet source MAC address
Answer: A

Which SDM template disables routing and supports the maximum number of unicast MAC addresses?
A. VLAN
B. access
C. default
D. routing
Answer: A


In a Cisco switch, what is the default period of time after which a MAC address ages out and is discarded?
A. 100 seconds
B. 180 seconds
C. 300 seconds
D. 600 seconds
Answer: C


Which feature is automatically enabled when a voice VLAN is configured, but not automatically disabled when a voice VLAN is removed?
A. portfast
B. port-security
C. spanning tree
D. storm control
Answer: A


Which VLAN range is eligible to be pruned when a network engineer enables VTP pruning on a switch?
A. VLANs 1-1001
B. VLANs 1-4094
C. VLANs 2-1001
D. VLANs 2-4094
Answer: C


When SDM templates are configured, which action must be performed for the configuration to take effect?
A: reload
B: shutdown
C: write memory
D: backup config
Answer: A

A network engineer wants to add a new switch to an existing switch stack.
Which configuration must be added to the new switch before it can be added to the switch stack?
A. No configuration must be added.
B. stack ID
C. IP address
D. VLAN information
E. VTP information
Answer: A


We are offering you detailed 300-115 CCNP SWITCH exam dumps. CertTree experts come from different parts of the Industry and are most experienced and qualified to have the opportunity to write the 300-115 CCNP SWITCH exam dumps. Studying with 300-115 CCNP SWITCH exam dumps guarantees your successes at your first attempt.Preparing with CertTree for the 300-115 examination will not just spend less your vitality and assets but time as well, because it has executed all that for you, what you may carry you weeks to achieve.