goo blog サービス終了のお知らせ 

Certtree IT exam latest material

Certtree IT exam download

CertTree Cisco CCNA ICND1 100-105 dumps

2017-11-02 11:39:16 | 日記
Many candidates who are ready to participate in the Cisco certification 100-105 exam may see many websites available online to provide resources about Cisco certification 100-105 exam. However, CertTree is the only website whose CertTree Cisco CCNA ICND1 100-105 dumps are developed by a study of the leading IT experts's reference materials. The CertTree Cisco CCNA ICND1 100-105 dumps of CertTree can ensure you pass your first time to participate in the Cisco certification 100-105 exam.


A lot of people in the discussion said that such a good certificate is difficult to pass and actually the pass rate is quite low. Not having done any efforts of preparation is not easy to pass, after all, Cisco certification 100-105 exam requires excellent expertise. Our CertTree is a website that can provide you with a shortcut to pass Cisco certification 100-105 exam. CertTree have CertTree Cisco CCNA ICND1 100-105 dumps of Cisco certification 100-105 exam which can ensure you pass Cisco certification 100-105 exam and gain certificate, but also can help you save a lot of time.
Share some CCENT 100-105 exam questions and answers below.
Which three statements are true about the operation of a full-duplex Ethernet network? (Choose three.)
A. There are no collisions in full-duplex mode.
B. A dedicated switch port is required for each full-duplex node.
C. Ethernet hub ports are preconfigured for full-duplex mode.
D. In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
E. The host network card and the switch port must be capable of operating in full-duplex mode.
Answer: A,B,E

Refer to the exhibit.



Which option describes how SwitchA will handle the frame just received?
A. It will drop the frame.
B. It will forward the frame out of port Fa0/3 only.
C. It will flood the frame out all ports.
D. It will flood the frame out of all the ports except Fa0/3.
Answer: D

Which network device functions only at Layer 1 of the OSI model?



A. Option A
B. Option B
C. Option C
D. Option D
E. Option E
Answer: B


Topic 3: Routing Fundamentals

Which IP addresses are valid for hosts belonging to the 10.1.160.0/20 subnet? (Choose three.)
A. 10.1.168.0
B. 10.1.176.1
C. 10.1.174.255
D. 10.1.160.255
E. 10.1.160.0
F. 10.1.175.255
Answer: A, C, D


Which OSI layer header contains the address of a destination host that is on another network?
A. application
B. session
C. transport
D. network
E. data link
F. physical
Answer: D


Which statements accurately describe CDP? (Choose three.)
A. CDP is an IEEE standard protocol.
B. CDP is a Cisco proprietary protocol.
C. CDP is a datalink layer protocol.
D. CDP is a network layer protocol.
E. CDP can discover directly connected neighboring Cisco devices.
F. CDP can discover Cisco devices that are not directly connected.
Answer: B, C, E


Refer to the exhibit.



The output is from a router in a large enterprise. From the output, determine the role of the router.
A. A Core router.
B. The HQ Internet gateway router.
C. The WAN router at the central site.
D. Remote stub router at a remote site.
Answer: D


Which transport layer protocol provides best-effort delivery service with no acknowledgment receipt required?
A. HTTP
B. IP
C. TCP
D. Telnet
E. UDP
Answer: E


Refer to the exhibit.



A network has been planned as shown.
Which three statements accurately describe the areas and devices in the network plan? (Choose three.)
A. Network Device A is a switch.
B. Network Device B is a switch.
C. Network Device A is a hub.
D. Network Device B is a hub.
E. Area 1 contains a Layer 2 device.
F. Area 2 contains a Layer 2 device.
Answer: A, D, E


Refer to the exhibit.



If the hubs in the graphic were replaced by switches, what would be virtually eliminated?
A. broadcast domains
B. repeater domains
C. Ethernet collisions
D. signal amplification
E. Ethernet broadcasts
Answer: C


Refer to the exhibit.



If host A sends an IP packet to host B, what will the source physical address be in the frame when it reaches host B?
A. 10.168.10.99
B. 10.168.11.88
C. A1:A1:A1:A1:A1:A1
D. B2:B2:B2:B2:B2:B2
E. C3:C3:C3:C3:C3:C3
F. D4:D4:D4:D4:D4:D4
Answer: E


What is the purpose of flow control?
A. To ensure data is retransmitted if an acknowledgement is not received.
B. To reassemble segments in the correct order at the destination device.
C. To provide a means for the receiver to govern the amount of data sent by the sender.
D. To regulate the size of each segment.
Answer: C


Which protocol uses a connection-oriented service to deliver files between end systems?
A. TFTP
B. DNS
C. FTP
D. SNMP
E. RIP
Answer: C


Which address type does a switch use to make selective forwarding decisions?
A. Source IP address
B. Destination IP address
C. Source and destination IP address
D. Source MAC address
E. Destination MAC address
Answer: E


What is the subnet address for the IP address 172.19.20.23/28?
A. 172.19.20.0
B. 172.19.20.15
C. 172.19.20.16
D. 172.19.20.20
E. 172.19.20.32
Answer: C



You can free download part of CertTree Cisco CCNA ICND1 100-105 dumps about Cisco certification 100-105 exam from CertTree website as a try to detect the quality of our products. Why CertTree can provide the comprehensive and high-quality information uniquely? Because we have a professional team of IT experts. They continue to use their IT knowledge and rich experience to study the previous years exams of Cisco 100-105 and have developed CertTree Cisco CCNA ICND1 100-105 dumps about Cisco 100-105 exam. So CertTree newest CertTree Cisco CCNA ICND1 100-105 dumps about Cisco certification 100-105 exam are so popular among the candidates participating in the 100-105 Cisco Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0).

CertTree CCNA certification 200-125 study guide

2017-11-02 11:27:46 | 日記
CertTree provide a good after-sales service for all customers. If you choose to purchase CertTree CertTree CCNA certification 200-125 study guide, CertTree will provide you with online service for 24 hours a day and one year free update service, which timely inform you the latest exam information to let you have a fully preparation. We can let you spend a small amount of time and money and pass the IT certification exam at the same time. Selecting the products of CertTree to help you pass your first time Cisco certification 200-125 exam is very cost-effective.

Share some CCNA Routing and Switching 200-125 exam questions and answers below.
A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server. What is the highest layer of the protocol stack that the network administrator is using for this operation?
A. application
B. presentation
C. session
D. transport
E. internet
F. data link
Answer: A

Which two statements about IPv4 multicast traffic are true? (Choose two.)
A. It burdens the source host without affecting remote hosts.
B. It uses a minimum amount of network bandwidth.
C. It is bandwidth-intensive.
D. It simultaneously delivers multiple streams of data.
E. It is the most efficient way to deliver data to multiple receivers.
Answer: BE

A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4.
Which route or routes will the router install in the routing table?
A. the OSPF route
B. the EIGRP route
C. the RIPv2 route
D. all three routes
E. the OSPF and RIPv2 routes
Answer: B

Which two spanning-tree port states does RSTP combine to allow faster convergence? (Choose two.)
A. blocking
B. listening
C. learning
D. forwarding
E. discarding
Answer: AB

Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?
A. R(config-if)#cdp run
B. R(config-if)#cdp enable
C. R(config)#cdp run
D. R(config)#cdp enable
Answer: C

For what two purposes does the Ethernet protocol use physical addresses? (Choose two.)
A. to uniquely identify devices at Layer 2
B. to allow communication with devices on a different network
C. to differentiate a Layer 2 frame from a Layer 3 packet
D. to establish a priority system to determine which device gets to transmit first
E. to allow communication between different devices on the same network
F. to allow detection of a remote device when its physical address is unknown
Answer: A,E

Which statement about RADIUS security is true?
A. It supports EAP authentication for connecting to wireless networks.
B. It provides encrypted multiprotocol support.
C. Device-administration packets are encrypted in their entirety.
D. It ensures that user activity is fully anonymous.
Answer: A

Two hosts are attached to a switch with the default configuration.
Which statement about the configuration is true?
A. IP routing must be enabled to allow the two hosts to communicate.
B. The two hosts are in the same broadcast domain.
C. The switch must be configured with a VLAN to allow the two hosts to communicate.
D. Port security prevents the hosts from connecting to the switch.
Answer: B

Which two statements about wireless LAN controllers are true? (Choose two.)
A. They can simplify the management and deployment of wireless LANs.
B. They rely on external firewalls for WLAN security.
C. They are best suited to smaller wireless networks.
D. They must be configured through a GUI over HTTP or HTTPS.
E. They can manage mobility policies at a systemwide level.
Answer: AE

What will be the result if the following configuration commands are implemented on a Cisco switch?
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security mac-address sticky
A. A dynamically learned MAC address is saved in the startup-configuration file.
B. A dynamically learned MAC address is saved in the running-configuration file.
C. A dynamically learned MAC address is saved in the VLAN database.
D. Statically configured MAC addresses are saved in the startup-configuration file if frames from that address are received.
E. Statically configured MAC addresses are saved in the running-configuration file if frames from that address are received.
Answer: B

Which interface counter can you use to diagnose a duplex mismatch problem?
A. no earner B. late collisions
C. giants
D. CRC errors
E. deferred
F. runts
Answer: B

A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-cisco router.
How should the network administrator configure the serial interface of the main office router to make the connection?
A. Main(config)#interface serial 0/0
Main(config-if)#ip address 172.16.1.1 255.255.255.252
Main(config-if)#no shut
B. Main(config)#interface serial 0/0
Main(config-if)#ip address 172.16.1.1 255.255.255.252
Main(config-if)#encapsulation ietf
Main(config-if)#no shut
C. Main(config)#interface serial 0/0
Main(config-if)#ip address 172.16.1.1 255.255.255.252
Main(config-if)#encapsulation frame-relay
Main(config-if)#authenication chap
Main(config-if)#no shut
D. Main(config)#interface serial 0/0
Main(config-if)#ip address 172.16.1.1 255.255.255.252
Main(config-if)#encapsulation ppp
Main(config-if)#no shut
Answer: D

Which feature can you implement to reserve bandwidth for VoIP calls across the call path?
A. PQ
B. CBWFQ
C. round robin
D. RSVP
Answer: D


Which two statements about IPv6 and routing protocols are true? (Choose two.)
A. EIGRPv3 was developed to support IPv6 routing.
B. OSPFv3 was developed to support IPv6 routing.
C. Loopback addresses are used to form routing adjacencies.
D. EIGRP, OSPF, and BGP are the only routing protocols that support IPv6.
E. Link-local addresses are used to form routing adjacencies.
Answer: BE

What are three characteristics of the TCP protocol? (Choose three.)
A. It uses a single SYN-ACK message to establish a connection.
B. The connection is established before data is transmitted.
C. It ensures that all data is transmitted and received by the remote device.
D. It supports significantly higher transmission speeds than UDP.
E. It requires applications to determine when data packets must be retransmitted.
F. It uses separate SYN and ACK messages to establish a connection.
Answer: BCF

CertTree CertTree CCNA certification 200-125 study guide are a good choice. It will help us to pass the exam successfully. This is the best shortcut to success. Everyone has the potenCiscol to succeed, the key is what kind of choice you have.Each IT person is working hard for promotion and salary increases. It is also a reflection of the pressure of modern society. We should use the strength to prove ourselves. Participate in the Cisco 200-125 exam please.


Cisco 200-125 exam is a challenging Certification Exam. Besides the books, internet is considered to be a treasure house of knowledge. In CertTree you can find your treasure house of knowledge. This is a site of great help to you. You will encounter the complex questions in the exam, but CertTree can help you to pass the exam easily. CertTree CertTree CCNA certification 200-125 study guide includes all the knowledge that must be mastered for the purpose of passing the Cisco 200-125 exam.