Revolutionary cutlery, no contact with table top

Conchita, I could do much today...

I must have had time, because I did not go
anywhere, except a quick dash to the shop
where I deposited my lack.

Naturally, my coating took up a lot of time,
mostly in the morning, but that is not new.

The culplit is the egg placers, I think.
See below.



To make 144 holes with only tsix plates I must have
spent more than one and half hours.

It made me think. This is no good. It takes
so much of my time. The problem is that I have
to move my drilling bit up and down manually,

also move it around manually. What I need is a PC
controlled milling machine. I wish I had one.



I al had to clean my peg bars. I did buy new ones,
but then I want to use those in stock. This also
took up some time.



And then came this peg making itself. I was wondering if
I really needed to produce so many of them, but then
if you count up the numbers, yes I must...

So, being bored I stopped half way through and
did the remaining dinosaurs, as seen below.



I am guessing that I now have something like 70, 80
of these beasts. Not too bad...



Once up in my room I still had to continue with
the pegs. Am I to continue with these tommorrow?
I suppose I will have to.

However, I am determined that I will start
fabricating baby feeders, with side bars.
It is something new.

Also, concaves...