CCNP TSHOOT 300-135 dumps|CertTree

CertTree is the only way that suits you to pass the exam, choose it equal to create a better future.CertTree training product for Cisco certification 300-135 exam includes simulation test and the current examination. On Internet you can also see a few websites to provide you the relevant training, but after compare them with us, you will find that CertTree CCNP TSHOOT 300-135 dumps|CertTree not only have more pertinence for the exam and higher quality, but also more comprehensive content.
Share some CCNP 300-135 exam questions and answers below.
The tunnel between R1 and R3 is not coming up. Which two statements are true? (Choose two)
(Topology with a GRE tunnel and the outputs provided are show ip int brief and tunnel source and destination)
A. Tunnel source int Eth0/0 is down
B. No route from R1 to R3 loopback0 (tunnel destination)
C. source and destination not in same subnet
D. http://bbs.hh010.com/
Answer: AB

The Fault Condition is related to which technology?
A. BGP
B. NAT
C. IP NAT
D. IPv4 OSPF Routing
E. IPv4 OSPF Redistribution
F. IPv6 OSPF Routing
G. IPv4 layer 3 security
Answer: C


The Fault Condition is related to which technology?
A. BGP
B. NAT
C. IP NAT
D. IPv4 OSPF Routing
E. IPv4 OSPF Redistribution
F. IPv6 OSPF Routing
G. IPv4 layer 3 security
Answer: G

How to check MTU of interface using ping? / How can you check the links mtu size with ping command?
A. ping 10.1.1.1 size 1501
B. ping 10.1.1.1 size 1500 df-bit
C. ping 10.1.1.1
D. ping 10.1.1.1 no-size
Answer: B

Two routers are connected through PPP connection. After the PPP was established the admin put OSPF running above it. The OSPF formed adjacency but after soon the adjacency dropped.
What is the reason? (The cause of OSPF forming an adjacency over a GRE tunnel and dropping immediately)
A. MTU does not match
B. Area 0 need to exist for OSPF to function properly
C. Gre tunnel destination is not reachable through tunnel
D. Gre tunnel ip address must be covered by network under ¡°router ospf 1¡±
E. ospf routes contains the route to tunnel destination
Answer: C

What is the solution to the fault condition?
A. Under the interface Tunnel34 configuration enter the ipv6 ospf 6 area 34 command.
B. Under the interface Loopback6 configuration enter the ipv6 ospf 6 area 34 command.
C. Under the interface Serial0/0/0.34 configuration enter the ipv6 ospf 6 area 34 command.
D. Under ipv6 router ospf 6 configuration enter the redistribute rip RIP_ZONE include-connected command.
Answer: D

What is the solution of the fault condition?
A. Under the BGP process,enter the bgp redistribute-internal command
B. Under the BGP process, bgp confederation identifier 65001 command
C. Delete the current BGP process and reenter all of the commands using 65002 as the AS number.
D. Under the BGP process, delete the neighbor 209.56.200.226 remote-as 65002 command enter the neighbor 209.65.200.226 remote-as 65002 command.
Answer: D

What is the solution of the fault condition?
A. Under the interface Serial0/0/0 configuration enter the ip nat inside command
B. Under the interface Serial0/0/1 configuration enter the ip nat outside command
C. Under the ip access-list standar nat_trafic configuration enter the permit 10.2.0.0 0.0.255.255 command
D. Under the ip access-list standar nat_trafic configuration enter the permit 209.65.200.0 0.0.0.255 command
Answer: C

What is the solution of the fault condition?
A. Under the interface Serial0/0/0 configuration enter the ip nat inside command
B. Under the interface Serial0/0/1 configuration enter the ip nat outside command
C. Under the ip access-list standar nat_trafic configuration enter the permit 10.2.0.0 0.0.255.255 command
D. Under the ip access-list standar nat_trafic configuration enter the permit 209.65.200.0 0.0.0.255 command
Answer: C


The Fault Condition is related to which technology?
A. BGP
B. NAT
C. IP NAT
D. IPv4 OSPF Routing
E. IPv4 OSPF Redistribution
F. IPv6 OSPF Routing
G. IPv4 layer 3 security
Answer: C

What is the solution to the fault condition?
A. Under the interface Tunnel34 configuration delete the tunnel mode ipv6 command.
B. Under the interface Serial0/0/0.34 configuration enter the ipv6 address 2026::34:1/122 command.
C. Under the interface Tunnel34 configuration enter the ip address unnumbered Serial0/0/0.34 command.
D. Under the interface Tunnel34 configuration delete the tunnel source Serial0/0/0.34 command and enter the tunnel source 2026::34:1/122 command.
Answer: A

R1 and R2 OSPF neighbor.
Which two statements are true? (Choose two)
(Output from show ip ospf neighbors on 2 routers, one of them shows FULL/DR, the other FULL/-, you need to know how were they configured and will they exchange routes)
A. They are not neighbors
B. R1 (non-DR) will not update its routes to R2
C. Router R2 is configured with ospf point-to-point command (R2 is the router that shows as FULL/-)
D. They need to be configured as OSPF NBMA
E. R2 should be configured as stub
Answer: BC

Ticket 4 NATACL

TROUBLE TICKET STATEMENT:

The implementation group has been using thetest bed to do a ¡®proof-of-concept¡¯that required both client 1 and client 2 to access the Web Server at 209.65.200.241.After several changed to interface status, network addressing, routing schemes and layer 2 connectivity, at trouble ticket has been opened indicating that client 1 cannot ping the 209.65.200.241 (internet Server).
show run by yourself to obtain the following information:
Configuration on R1
ip nat inside source list nat_pool interface Serial0/0/0/1 overload !
ip access-list standard nat_pool
permit 10.1.0.0
! interface Serial0/0/0/1
ip address 209.65.200.224 255.255.255.252
ip nat outside
! interfaceSerial0/0/0/0.12
ip address 10.1.1.1 255.255.255.252
ip nat inside
ip ospf message-digest-key 1 md5 TSHOOT
ip ospd authentication message-digest

On Which device is the fault condition located?
A. R1
B. R2
C. R3
D. R4
E. DSW1
F. DSW2
G. ASW1
Answer: A


The Fault Condition is related to which technology?
A. BGP
B. NTP
C. IP NAT
D. IPv4 OSPF Routing
E. IPv4 OSPF Redistribution
F. IPv6 OSPF Routing
G. IPv4 layer 3 security
Answer: A


The fault condition is related to which technology?
A. NTP
B. IP DHCP Server
C. IPv4 OSPF Routing
D. IPv4 EIGRP Routing
E. IPv4 Route Redistribution
F. IPv6 RIP Routing
G. IPv6 OSPF Routing
H. IPV4 and IPV6 Interoperability
I. IPv4 layer 3 security
Answer: G


CertTree, as a provider, specializing in providing all candidates with IT exam-related materials,focus on offering the most excellent CCNP TSHOOT 300-135 dumps|CertTree for the candidates. In contrast with other websites, CertTree is more trustworthy. Why? Because CertTree has many years of experience and our IT experts have been devoted themselves to the study of IT certification exam and summarize IT exam rules. Thus, CertTree CCNP TSHOOT 300-135 dumps|CertTree have a high hit rate. Meanwhile, it guarantees the qualification rate in the exam. Therefore, CertTree got everyone's trust.


300-135 test is a very valuable and important exam of Cisco Certification. 300-135 exam is a very authentic and very much valuable exam for the IT professionals. 300-135 exam is an ideal exam for those IT professionals who want to improve their skills, talent and knowledge about the information technology. CCNP TSHOOT 300-135 dumps|CertTree from CertTree will certainly assist you in gaining the knowledge and experience needed to study for your 300-135 exam. CCNP TSHOOT 300-135 dumps|CertTree are very advanced and always updated with the changing 300-135 Exam Objectives to equip you with all the necessary concepts and ideas to succeed in both the 300-135 Exam and Practical Life.