Thrust ball bearing is a very simple structure

Thrust ball bearing is a very simple structure. The main structure includes parts such as shaft washer, seat ring and rolling body. This structure is separated, so it is easy to install and disassemble, but because this structure can only withstand Axial load in one direction, so it is basically more common on lower speed equipment. However, due to the restrictions on the use of crane hooks, vertical pumps, vertical centrifuges, jacks, low-speed reducers and other equipment, we need to frequently load and unload thrust ball bearings. 

Let's take a look at the installation points: 

1, The solid cage needs to be installed in a suitable range, otherwise too deep will cause the steel ball to move too little, and too shallow will cause the embossing to be raised, so the strength of the connecting part of the two is not enough to cause the problem of shedding and scrapping. 

2, M-type stamping cage uses a flange assembly mold. After pressing, the steel ball is required to rotate flexibly in the pocket hole, but it cannot fall off from the 6301 ball bearing pocket hole, and the technical regulations check the amount of movement of the steel ball in the pocket hole. In fact, a brief summary of the above points is that the quality control of the thrust ball bearing cage and steel ball compression makes us focus on the installation process.

Structure of thrust ball bearing

Thrust ball bearings are commonly used in the industry as a support part for vibration motors and other equipment. Although the structure of this part is very simple, because the use of this part is slightly different, it may lead to many different installation diagrams, so the following We have asked the manufacturer of the bearing to introduce the installation method of the bearing: First, after we get the drawing, we usually check the corresponding structure of the part according to the drawing. 

The main structure of the thrust ball bearing is generally the shaft ring and the seat ring. , Cage, steel ball, etc. This is a separate part, so it needs to be confirmed with the corresponding parts before it can be installed correctly. Second, when we install according to the drawing, we must pay attention to the installation order of the upper and lower bearings, because the size of the bearings ring manufacturers upper and lower seat rings is significantly different, so extra care must be taken not to install it in the opposite direction. 3. In addition, we should also pay attention to that after installing the thrust ball bearing, we must check whether the bearing is running flexibly and whether the clearance is too loose or too tight.