fiber optical communication

Share information about fiber optic!

AC Switch vs DC Switch: What's the Difference?

2018-07-18 16:27:39 | Switch

The first step on integrating a switch into the network is to get it powered up. And as to power supply, there are AC and DC power for network switch, both of which are used for increasing network uptime. Then what’s the difference between AC power Switch and DC power switch? Which type shall we used for our network? This post will give a detailed introduction for the difference between AC Switch and DC switch, and set out how to make a proper decision over AC Switch vs DC Switch.

AC Switch vs DC Switch: What Are They?

AC powered Ethernet switch often has a fixed AC power supply connector, thus it generally gets powered up through power cables such as IEC power cord, NEMA power cord, etc. PoE switches are typical AC switches. Take FS 24 port PoE switch as example, which is equipped with a single 100-240V AC power supply connector (as shown below). It is easy to power up AC switch. All you need to do is connect it to the power socket with proper power cable. For some advanced network switch, turning on its power switch is also necessary.

AC switch vs DC switch

DC powered Ethernet switch can be configured with an internal or external DC power supply. And the external DC power supply is more popular nowadays, which is also known as redundant power supply. Modern fiber switch often has more than one redundant power supply (e.g the following FS 10GbE switch is equipped with two DC power supply). Except for powering up switch, the DC redundant power supply can also protect other power supply when it fails with shorted outputs.

AC switch vs DC switch

AC Switch vs DC Switch: What's the Difference?

In the market, there are Ethernet switches that support only AC power supply or DC power supply, and there are also some switches which can be used with both AC and DC power supplies. However, the switch can only support one type of power supply at the same time. That’s to say, if you use DC power supply to power up your switch initially, the switch will detect it and operate with DC power. In this case, AC power supply installed in the switch will be disabled. Even if you try to install AC power supply when the switch is operating with DC power, it will also disable the AC power and generates an alarm. So remember not to mix AC and DC power supplies in a switch.

Conclusion

AC and DC power supplied Ethernet switches are all commonly used nowadays. You can select one or the other according to your own case and needs. FS provides both AC and DC switches. For example, we have AC switches such as 8/24/48 port PoE+ Managed Switches which support up to 600W. High quality DC switches are also available. Customers can also custom the power type of switches.

Originally published at http://www.fiber-optic-transceiver-module.com/ac-switch-vs-dc-switch-whats-the-difference.html

ジャンル:
ウェブログ
コメント   この記事についてブログを書く
« VLAN vs Subnet: What Are Th... | トップ | EVPN vs VPLS: What Are They... »

コメントを投稿

Switch」カテゴリの最新記事