Ore milling equipment is a kind of grinding equipment widely used in mine, cement plant, chemical plant and so on. It is one of the important equipment for deep processing of non-metallic minerals. Because of the ore milling equipment in zimbabwe has stable performance, strong adaptability and high performance price ratio, it has been widely used in the processing of non-metallic minerals since the introduction of for several decades. Based on the ultrafine powder processing technology that we have mastered for many years, we carried out a thorough and thorough technological renovation to the above problems, and made a lot of updates and improvements to the structure of ore mill. The transformation of the traditional ore milling equipment needs our efforts, at the same time, we also hope that the grinding industry in China can have a super good prospect.
The ore pulverizer is a new, high efficiency, high efficiency and closed - circuit pulverizing equipment which can replace the ball mill. Because it has many advantages, which can be adapted to small and medium-sized mines, chemical industry, metallurgy, building materials, refractory materials, pharmaceutical, cement and other industries, are widely used in metallurgy, building materials, chemical industry, mining and other fields, grinding processing industrial products, suitable for processing the following Mohs hardness of seven, in a variety of humidity below 6% non inflammable minerals, such as gypsum, talc, calcite, limestone, marble, feldspar, dolomite, barite, granite, kaolin, Peng Runtu, stone, bauxite, iron oxide red, iron ore, refined fine degrees in six hundred ~ four hundred microns microns, through interaction analysis machine and fan, can meet the requirements of different users.
The existing problems of the traditional ore mill have been puzzling the mineral processing enterprises and equipment manufacturers. These problems are mainly reflected in the following aspects: the fineness of products is low, and the fineness of common grinding is generally below five hundred mesh. These devices can only occupy the lower end of the powder application market. The mechanical failure rate is relatively high, the power consumption is relatively large, the noise is large, serious pollution emissions, the system efficiency is relatively low, the product collection system separation effect is not ideal, a large number of fine powder is not effectively collected and repeat the cycle in the system caused by the power waste, the host is not suitable for the design of bellows duct milling production line after optimization, into larger particles in the material grinding area and the future and particle grinding broken is often thrown into the bellows gathered in the volute tail box, and continue to extend forward, the wind gradually reduced, causing traffic jams, no less powder or powder, the ultimate impact of production.
According to the years of mastery of the superfine powder processing technology equipment, to carry on the thorough technical innovation, a lot of renewal and transformation of ore milling machine structure, the traditional way of the host was improved, and the spindle has a quincunx structure transformation to stable and keep it running smoothly.